The props for this BNF press fit on and do not screw into the motor (much like many other Whoops & Toothpicks)

The Darwin Baby Ape has been loved by many pilots as soon as it was published. In order to design a better FPV drone, DarwinFPV upgraded the Baby Ape based on the pilots' feedback and launched the BabyApe Pro V2.

Darwin made several upgrades to the frame. First of all, nylon standoffs are upgraded to aluminum alloy standoffs, which strengthens the frame and stables structure.

Second, they added the receiver fixing bracket.

Third, they upgraded the arms. The arms are upgraded from 4 individual arms (2.5mm thickness) to 2 integrated arms (3.0mm thickness). It is easier to disassemble, sturdy, and durable.

Lastly, the V2 version only needs 4 screws to fix, and the arm can be replaced by removing 2 screws without removing the whole drone.

Make sure to check out all of our as well as the rest of our !

Specifications

Motors

• Input Voltage: 2-3S
• Stator Size: 11x4mm
• Kv: 4300

AIO

• MCU: STM32F411
• Gyro: MPU6000
• BEC: 5V/2A,3.3V
• Input voltage: 1-3S Lipo
• Support Receiver: PPM, Ibus, Sbus, Dsmx
• Black box: NO
• Barometer: NO
• Firmware: MATEKF411
• Buzzer interface: YES
• Betaflight OSD: AT7456E
• Constant current: 15A
• Peak current: 17A
• MCU: EFM8BB21F16G(48MHz)
• Firmware: BLHeli_S
• Protocol: Dshot600
• Mounting: 25.5X25.5 M2

VTX

• Input Voltage: 7V~24V
• RF Output Power: 0mW/25mW/100mW/200mW switchable
• Antenna Connector: U.FL

Caddx Ant Camera

• Model: Caddx Ant
• Image Sensor: 1/3" CMOS
• Resolution: 1200TVL
• Signal System: PAL/NTSC

Includes

• 1x DarwinFPV BNF Baby Ape Pro V2 3" Quad - Plug-N-Play - Choose Version