Motion Sensor:

When the working mode is selected, the IR light keep working in the dark. When motion is detected, it will switch to highlight mode. When a person has left for 20 seconds, it will switch to the mode you selected.

Installation:

• After receiving the light, press the switch button for 3 seconds on the back of the solar panel to turn it on, and then fully cover the solar panel, if the light is on, that indicate the light is good and working, if the flood light is not on, please make sure to fully charge it in the sunshine, then operate again.
• Use the screws in the package to install the light on the wall and cover the area you want to illuminate.
• After installation, adjust the solar panel angle, and ensure that the panel can directly get the sunlight without any obstruction or glass barrier. In normal condition, it can be fully charged in 4 hours in ideal sunlight.

Starting and Mode Selection:

• Press the switch button for 3 seconds, turn the light on and meanwhile enter working mode 1
• Mode 1: Slight light at night + strong light after motion detected.
• Mode 2: No light at night + strong light after motion detected on this mode, a red light keeps flashing.

(Note: The red light does not working on other modes)

• Mode 3: Normally lighting at night (keep lighting for 4 hours, it will change to dim light)
• Press button to turns off.